Accent Cover Trim Application and Removal Instructions For Jeep Wrangler and Jeep Gladiator

1 comment Aug 18, 2021

Items Needed for EASIEST Install:

  • Clean, warm, dry area to work in
  • Rubbing alcohol and rag or alcohol prep wipes
  • Adhesion promotor and rag or primer wipes - available at local automotive store or on Amazon
  • Tweezers
  • OPTIONAL Hair Dryer or heat source

👩‍🏫 Step By Step Instructions:

  1. Wipe down surface with rubbing alcohol to remove dirt, debris and dust
  2. Apply adhesion promotor to a rag and wipe down the area to be covered with trim
  3. Remove the backing from the 3M double sided tape on the trim piece
  4. Position trim piece over area to be covered and press firmly into place, holding pressure for 30-60 seconds

⚠️ Tips & Tricks:

  • Avoid spraying adhesion promotor directly on vehicle surface as overspray will make things tacky and be hard to clean up
  • Tweezers can make removing the tape backing MUCH easier
  • Have a trash can handy for the tape backing trash, there will be a good bit of it!
  • Use a heat source if plastic needs slight molding to fit properly but avoid overheating and melting the plastic

⁉️ Have Questions or Need More Help?

Check out our full selection of videos on Youtube or reach out to us through our contact form, call us at 843-516-7147 or email us at colormyjeep@gmail.com


1 comment


  • Ann August 7, 2023 at 9:29 pm

    How do you remove the trim kits?


Leave a comment

Please note, comments must be approved before they are published

This site is protected by reCAPTCHA and the Google Privacy Policy and Terms of Service apply.